MAX4530 查看數據表（PDF） - Maxim Integrated
零件编号
产品描述 (功能)
生产厂家
MAX4530
Maxim Integrated
MAX4530 Datasheet PDF : 16 Pages
| |||
Low-Voltage, CMOS Analog Multiplexers/Switches
with Enable Inputs and Address Latching
ELECTRICAL CHARACTERISTICS—Single +3V Supply
(V+ = +2.7V to 3.6V, V- = 0V, GND = 0V, VADD_H = VEN_H = VLE = 2.4V, VADD_L = VEN_L = 0.5V, TA = TMIN to TMAX, unless
otherwise noted.)
PARAMETER
SYMBOL
CONDITIONS
MIN TYP MAX
(Note 2)
UNITS
SWITCH
Analog Signal Range
VANALOG (Note 3)
0
V+
V
On-Resistance
RON
INO = 1mA, VCOM = 1.5V,
V+ = 2.7V
TA = +25°C
TA = TMIN to TMAX
220 500
Ω
600
DYNAMIC
Transition Time (Note 3)
tTRANS
Figure 1, VIN = 2.4V,
VNO1 = 1.5V, VNO8 = 0V
TA = +25°C
150 350
ns
Enable Turn-On Time
(Note 3)
tON(EN)
Figure 3, VINH = 2.4V,
VINL = 0V, VNO1 = 1.5V
TA = +25°C
150 350
ns
Enable Turn-Off Time
(Note 3)
tOFF(EN)
Figure 3, VINH = 2.4V,
VINL = 0V, VNO1 = 1.5V
TA = +25°C
60 150
ns
Set-Up Time, Channel
Select to Latch Enable)
tS
Note 3
TA = +25°C
100
ns
Hold Time, Latch Enable to
Channel Select
tH
Note 3
TA = +25°C
0
ns
Pulse Width, Latch Enable
tMPW Note 3
TA = +25°C
120
ns
Note 2: The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in
this data sheet.
Note 3: Guaranteed by design.
Note 4: ∆RON = RON(max) - RON(min).
Note 5: Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the
specified analog signal ranges, i.e., VNO = 3V to 0V and 0V to -3V.
Note 6: Leakage parameters are 100% tested at maximum rated hot operating temperature, and guaranteed by correlation at
TA = +25°C.
Note 7: Worst-case isolation is on channel 4 because of its proximity to the COM pin. Off isolation = 20log VCOM / VNO,
VCOM = output, VNO = input to off switch.
Note 8: Leakage testing at single supply is guaranteed by correlation testing with dual supplies.
6 _______________________________________________________________________________________
Share Link: