HIP4086 查看數據表（PDF） - Renesas Electronics

零件编号

产品描述 (功能)

生产厂家

HIP4086

80V, 500mA, 3-Phase MOSFET Driver

Renesas Electronics 

HIP4086, HIP4086A

80V, 500mA, 3-Phase MOSFET Driver

The HIP4086 and HIP4086A (referred to as the HIP4086/A)

are 3-phase N-channel MOSFET drivers. Both parts are

specifically targeted for PWM motor control. These drivers

have flexible input protocol for driving every possible switch

combination. The user can even override the shoot-through

protection for switched reluctance applications.

The HIP4086/A have a wide range of programmable dead

times (0.5µs to 4.5µs) which makes them very suitable for the

low frequencies (up to 100kHz) typically used for motor drives.

The only difference between the HIP4086 and the HIP4086A

is that the HIP4086A has the built-in charge pumps disabled.

This is useful in applications that require very quiet EMI

performance (the charge pumps operate at 10MHz). The

advantage of the HIP4086 is that the built-in charge pumps

allow indefinitely long on times for the high-side drivers.

To insure that the high-side driver boot capacitors are fully

charged prior to turning on, a programmable bootstrap refresh

pulse is activated when VDD is first applied. When active, the

refresh pulse turns on all three of the low-side bridge FETs

while holding off the three high-side bridge FETs to charge the

high-side boot capacitors. After the refresh pulse clears,

normal operation begins.

Another useful feature of the HIP4086/A is the programmable

undervoltage set point. The set point range varies from 6.6V to

8.5V.

TABLE 1. KEY DIFFERENCES BETWEEN FAMILY OF PARTS

PART NUMBER

CHARGE

PUMP

HIP4086

Yes

HIP4086A

No

DATASHEET

FN4220

Rev 1.00

January 12, 2017

Features

• Independently drives 6 N-channel MOSFETs in 3-phase

bridge configuration

• Bootstrap supply maximum voltage up to 95VDC with bias

supply from 7V to 15V

• 1.25A peak turn-off current

• User programmable dead time (0.5µs to 4.5µs)

• Bootstrap and optional charge pump maintain the high-side

driver bias voltage.

• Programmable bootstrap refresh time

• Drives 1000pF load with typical rise time of 20ns and fall

time of 10ns

• Programmable undervoltage set point

Applications

• Brushless Motors (BLDC)

• 3-phase AC motors

• Switched reluctance motor drives

• Battery powered vehicles

• Battery powered tools

Related Literature

• AN9642, “HIP4086 3-Phase Bridge Driver Configurations

and Applications”

• AN1829, “HIP4086 3-Phase BLDC Motor Drive

Demonstration Board, User Guide”

VDD

Speed

Controller

Brake

VDD

RDEL

AHI

ALI

BHI

BLI

CHI

CLI

CHB

BHB

AHB

AHO

BHO

CHO

CHS

BHS

AHS

VSS

ALO

BLO

CLO

Battery

24V...48V

FIGURE 1. TYPICAL APPLICATION

FN4220 Rev 1.00

January 12, 2017

200

VxHB - VxHS = 10V

150

100

50

0

-60 -40 -20 0 20 40 60 80 100 120 140 160

JUNCTION TEMPERATURE (°C)

FIGURE 2. CHARGE PUMP OUTPUT CURRENT

Page 1 of 17

Share Link: