DS1780E 查看數據表（PDF） - Maxim Integrated
零件编号
产品描述 (功能)
生产厂家
DS1780E Datasheet PDF : 28 Pages
| |||
INTERRUPT INT STATUS REGISTER 2 (ADDRESS 0X42; POWER-UP
DEFAULT=00h) Table 10.4
BIT NAME R/W
DESCRIPTION
0 +12V_Error R A 1 indicates a High or Low limit has been exceeded.
1
-12V/
VCCP2_Error
R A 1 indicates a High or Low limit has been exceeded.
2
Reserved
R0
3
Reserved
R0
4 Chassis_Error R A 1 indicates Chassis Intrusion has gone high.
5
Reserved
R0
6
Reserved
R0
7
Reserved
R0
DS1780
Note: Anytime the INT Status Registers are read out, the conditions (i.e., Registers) that are read are
automatically reset to power-up state (except CHS, which can only be cleared by CHS reset). In the case
of the VOLTAGE priority indication, if two or more voltages were out of LIMITS, then another
indication would automatically be generated if it were not handled during the ISR.
The errant voltage may be masked until the operator has time to clear the errant condition or set the limit
higher/lower.
INT MASK REGISTER 1 (ADDRESS 0X43; POWER-UP DEFAULT=00h)
Table 10.5
BIT NAME R/W
DESCRIPTION
0
+2.5V
R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
1
+VCCP1
R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
2
+3.3V
R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
3
+5V
R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
4
Temp
R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
5
Reserved R/W Power on default = 0.
6
FAN1
R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
7
FAN2
R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
INT MASK REGISTER 2 (ADDRESS 0X44; POWER-UP DEFAULT=00h)
Table 10.6
BIT NAME R/W
DESCRIPTION
0
+12V
R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
1 -12V/VCCP2 R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
2
Reserved R/W Power-up Default = 0.
3
Reserved R/W Power-up Default = 0.
CHS_sec
4
(Chassis R/W A 1 disables the corresponding interrupt status bit for INT interrupt.
Intrusion)
5
Reserved R/W Power-up Default = 0.
6
Reserved R/W Power-up Default = 0.
7 Reset Enable R/W A 1 enables the RESET in the configuration register.
18 of 28
Share Link: 