ISL8200AMM 查看數據表（PDF） - Renesas Electronics
零件编号
产品描述 (功能)
生产厂家
ISL8200AMM Datasheet PDF : 24 Pages
| |||
ISL8200AMM
Absolute Maximum Ratings
Input Voltage, PVIN, VIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +27V
Driver Bias Voltage, PVCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +6.0V
Signal Bias Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +6.5V
BOOT/UGATE Voltage, VBOOT . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +36V
Phase Voltage, VPHASE . . . . . . . . . . . . . . . . . . . VBOOT - 7V to VBOOT + 0.3V
BOOT to PHASE Voltage,
VBOOT - VPHASE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to VCC + 0.3V
Input, Output or I/O Voltage . . . . . . . . . . . . . . . . . . . . . . -0.3V to VCC + 0.3V
ESD Rating
Human Body Model (Tested per JESD22-A114E) . . . . . . . . . . . . . . . . 2kV
Machine Model (Tested per JESD22-A115-A) . . . . . . . . . . . . . . . . . 200V
Charge Device Model (Tested per JESD22-C101C). . . . . . . . . . . . . . . 1kV
Latch-up (Tested per JESD-78B; Class 2, Level A) . . . . . . . . . . . . . . 100mA
Thermal Information
Thermal Resistance (Typical)
JA (°C/W) JC (°C/W)
QFN Package (Notes 3, 4) . . . . . . . . . . . . . .
13
2.0
Maximum Storage Temperature Range . . . . . . . . . . . . . .-55°C to +150°C
Recommended Operating Conditions
Input Voltage, PVIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3V to 20V
Input Bias Voltage, VIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5V to 20V
Driver Bias Voltage, PVCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5V to 5.6V
Signal Bias Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4.5V to 5.6V
Boot to Phase Voltage
VBOOT - VPHASE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <6V
Ambient Temperature Range . . . . . . . . . . . . . . . . . . . . . . .-55°C to +125°C
Junction Temperature Range . . . . . . . . . . . . . . . . . . . . . . .-55°C to +125°C
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product
reliability and result in failures not covered by warranty.
NOTES:
3. JA is measured in free air with the component mounted on a high effective thermal conductivity test board (i.e., 4-layer type without thermal vias -
see tech brief TB379) per JEDEC standards except that the top and bottom layers assume solid plains.
4. For JC, the “case temp” location is the center of the exposed metal pad on the package underside.
Electrical Specifications Boldface limits apply across the operating temperature range, -55°C to +125°C.
PARAMETER
SYMBOL
TEST CONDITIONS
MIN
(Note 6)
VCC SUPPLY CURRENT
Nominal Supply VIN Current
Nominal Supply VIN Current
Shutdown Supply VCC Current
INTERNAL LINEAR REGULATOR
IQ_VIN
IQ_VIN
IVCC
PVIN = VIN = 20V; No Load; fSW = 700kHz
PVIN = VIN = 4.5V; No Load; fSW = 700kHz
EN = 0V, VCC = 2.97V
Maximum Current
Saturated Equivalent Impedance
POWER-ON RESET
IPVCC
RLDO
PVCC = 4V to 5.6V
P-Channel MOSFET (VIN = 5V)
Rising VCC Threshold
Falling VCC Threshold
Rising PVCC Threshold
Falling PVCC Threshold
System Soft-start Delay
tSS_DLY
After PLL, VCC, and PVCC PORs, and EN above
their thresholds
ENABLE
Turn-On Threshold Voltage
(Note 7)
Hysteresis Sink Current
Undervoltage Lockout Hysteresis
Sink Current
Sink Impedance
OSCILLATOR
IEN_HYS
VEN_HYS
IEN_SINK
REN_SINK
VEN_RTH = 10.6V; VEN_FTH = 9V
RUP = 53.6kΩ, RDOWN = 5.23kΩ
VEN = 1V
VEN = 1V
(Note 7)
(Note 7)
Oscillator Frequency
FOSC
RFS = 59kΩFigure 34
Total Variation
VCC = 5V;
FREQUENCY SYNCHRONIZATION AND PHASE LOCK LOOP (Note 7)
(Note 7)
Synchronization Frequency
VCC = 5.4V
FOSC
TYP
(Note 5)
36
27
9
320
1
2.85
2.65
2.85
2.65
384
0.8
30
1.6
700
MAX
(Note 6)
(Note 7)
(Note 7)
(Note 7)
(Note 7)
(Note 7)
(Note 7)
(Note 7)
(Note 7)
(Note 7)
UNIT
mA
mA
mA
mA
Ω
V
V
V
V
Cycles
V
µA
V
mA
Ω
kHz
%
kHz
FN8287 Rev 2.00
June 3, 2015
Page 7 of 24
Share Link: 