2008618-1 查看數據表（PDF） - Tyco Electronics
零件编号
产品描述 (功能)
生产厂家
2008618-1 Datasheet PDF : 6 Pages
| |||
Industrial Circular Ethernet Panel-Mount Connector System
408-8933
Detail A
Assembling Plug Kit
Wide Slot
Locking
Tab
Cable
Recommended Panel Cutout
Maximum Panel Thickness: 3.18 mm [.125 in.]
Flat Edge
(Customer Located)
12.93+0.10 mm
[.509+.004 in.]
Detail B
Strain Relief
27.18 mm
[1.07 in.]
Modular Plug (Shown)
Fully Seated
Note: Not to Scale
Rotate Strain Relief
As Shown
Figure 7
28.50+0.15/-0.08 mm
[1.122+.006/-.003 in.]
12.7 mm [.50 in.]
Approx
STRAIN RELIEF TORQUE RANGE
PLASTIC SHELL
METAL SHELL
1.7-2.8 N-m [15-25 lbf-in.]
0.9-1.4 N-m [8-12 lbf-in.]
Figure 6
2. Slide the panel gasket over the front (end with
bayonet lock) of the receptacle assembly for rear
panel mount or over the back of the receptacle
assembly for front panel mount until it is flat
against the flange. See Figure 8.
3. Align the flat of the receptacle assembly with the
flat edge of the panel cutout, and insert the
receptacle assembly into the panel until the panel
gasket is flat against the panel.
4. Thread the panel nut onto the front of the
receptacle assembly (for rear panel mount) or onto
the back (for front panel mount) and using a torque
tool, tighten to a torque of 2.26 N–m [20 lbf–in.].
Make sure that the panel nut is flat against the
panel.
NOTE
i
The given torque must be met in order for the
panel gasket to seal the receptacle at the panel.
3.3. Protective Cover Assembly (Refer to Figure 9)
If using the protective cover, proceed as follows:
1. For the plug assembly, slide the loop of the
tether over the back (end with the cable fitting) of
Assembling Receptacle Kit
Note: Rear Panel Mount Shown
Flat Edge
Bayonet Lock (Front of
Receptacle Assembly)
Panel
Gasket
Panel
Nut
Flat
Flange
Front of
Panel
Figure 8
the plug assembly until it is in the groove at the
back of the plug assembly. For the receptacle
assembly, slide the loop of the tether over the front
(end with bayonet lock) of receptacle assembly
until it is in the groove at the front of the receptacle
assembly.
2. If not engaging connectors immediately, install
the protective cover. For the plug assembly, align
the slots of the bayonet lock with the protrusions
(located inside) of the plug assembly; for the
receptacle assembly, align the protrusions (located
inside) of the cover with the slots of the bayonet
lock of the receptacle assembly. Then rotate the
cover until the protrusions “click” onto the bayonet
lock.
Rev D
Tyco Electronics Corporation
5 of 6
Share Link: 