2008618-1 查看數據表（PDF） - Tyco Electronics
零件编号
产品描述 (功能)
生产厂家
2008618-1 Datasheet PDF : 6 Pages
| |||
Industrial Circular Ethernet Panel-Mount Connector System
Installing Protective Cover Assembly
Protective
Cover
Connector Engagement
Common Core
Assembly
Latch
408-8933
Tether in Groove at Front
of Receptacle Assembly
Tether in Groove at
Back of Plug Assembly
Small Slot of
Modular Jack
Back of
Panel
Modular Plug
Locking
Tab
Coupling Ring of
Plug Assembly
Protective
Cover
Panel (Ref)
Figure 9
4. ENGAGEMENT (Refer to Figure 10)
1. Align the locking tab (modular plug) or the latch
(common core assembly, located at the end of the
bottom shield) with the small slot of the modular
jack.
2. Rotate the coupling ring of the plug assembly
until the protrusions (located inside the coupling
ring) align with the slots of the bayonet lock of the
receptacle assembly.
3. Engage the plug assembly to the receptacle
assembly, then rotate the coupling ring until the
protrusions “click” onto the bayonet lock.
NOTE
i
For detailed assembly and inspection
requirements, refer to Application Specification
114-13136.
Back of
Receptacle
Assembly
Protrusion
(3 Places)
Slot (3 Places)
of Bayonet Lock
Tether of Protective
Cover (Ref)
Figure 10
5. REPLACEMENT AND REPAIR
Components of the kits and protective cover
assembly are not repairable. DO NOT use defective
or damaged components. DO NOT re–use plug
assemblies by removing the cable.
6. REVISION SUMMARY
Revisions to this instruction sheet include:
S Changed metal shell torque range in Figure 6
6 of 6
Tyco Electronics Corporation
Rev D
Share Link: 