S-24C08C 查看數據表（PDF） - Seiko Instruments Inc

零件编号

产品描述 (功能)

生产厂家

S-24C08C

2-WIRE SERIAL E2PROM

Seiko Instruments Inc 

Rev.1.0_00_H

2-WIRE SERIAL E2PROM

S-24C08C (WLP PRODUCT)

5. Device addressing

To start communication, the master device on the system generates a start condition to the bus line. Next, the

master device sends 7-bit device address and a 1-bit read / write instruction code on to the SDA bus.

The upper 4 bits of the device address are the “Device Code”, and are fixed to “1010”.

In the S-24C08C, successive 1 bit is called the “Slave Addrdess”. This 1 bit is used to identify a device on the system

bus and is compared with the predetermined value which is defined by the address input pin (A2). When the

comparison result matches, the slave device responds with an acknowledge during the 9th clocks cycle.

The successive 2 bits (P1 and P0) are used to define a page address and choose the four 256-byte memory blocks

(Address 000h to 0FFh, 100h to 1FFh, 200h to 2FFh and 300h to 3FFh).

Device Code

1

0

1

0

MSB

Slave / Page

Address

A2 P1 P0 R / W

LSB

Figure 10 Device Address

11

Share Link: