NT68P81 查看數據表（PDF） - Novatek Microelectronics

零件编号

产品描述 (功能)

生产厂家

NT68P81

USB Keyboard Micro-Controller

Novatek Microelectronics 

NT68P81

8. Base Timer (BT)

The Base Timer is an 8 -bit counter with a programmable clock source selection. The BT can be enabled/disabled by the

CPU. After reset, the BT is disabled and cleared. The BT can be preset by writing a preset value to BT7 ~ BT0 of the BT

register at any time. When the BT is enabled, the BT starts counting from the preset value. When the value reaches FFH, it

generates a timer interrupt if the timer interrupt is enabled. When it reaches the maximum value of FFH, the BT will wrap

around and begin counting at 00H. The BT can be enabled by writing a "0" to " ENBT " bit in the TCON (Timer Control)

register. The ENBT signal is level trigger.

The input clock source of BT is controlled by the TMOD register. The following table shows 8 ranges of the BT.

TM2

TM1

TM0

Pre-scalar Ratio

Min. Count

Max. Count

0

0

0

System Clock/23

1.33 µs

341.33 µs

0

0

1

System Clock/24

2.66 µs

682.66 µs

0

1

0

System Clock/25

5.32 µs

1.36 ms

0

1

1

System Clock/26

10.64 µs

2.72 ms

1

0

0

System Clock/27

21.28 µs

5.44 ms

1

0

1

System Clock/28

42.56 µs

10.89 ms

1

1

0

System Clock/29

85.12 µs

21.79 ms

1

1

1

System Clock/210

170.24 µs

43.58 ms

For counting accuracy, please set the TMOD register first, then preset the BT register, and enable the base timer finally.

(TM2, TM1, TM0) = (1, 1, 1) is reserved for USB driver use.

15

Share Link: