L6566BH 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

L6566BH

Multimode controller for SMPS

STMicroelectronics 

Application information

L6566BH

prevent any malfunction during transients from minimum to maximum load the normal

(higher) UVLO threshold is re-established when the voltage at the COMP pin exceeds

VCOMPL and Vcc has exceeded the normal UVLO threshold (see Figure 13). The normal

UVLO threshold ensures that at full load the MOSFET is driven with a proper gate-to-source

voltage.

Figure 13. Adaptive UVLO block

COMP 9

-

+

V C OMPL

V C OMPO

+

-

R

S

Q

Vcc OFF1

Vc c

5

UVLO

+

SW

-

Vcc OFF2

(*)

L6566BH

(*) VccOFF2< VccOFF1is selected when Q is high

VCOMP

(pin 9)

VC OMPL

VC OMPO

Vcc

(pin 5)

V c cOFF1

V c cOFF2

Q

t

t

t

AM11489v1

5.5

PWM control block

The device is specific to secondary feedback. Typically, there is a TL431 on the secondary

side and an optocoupler that transfers output voltage information to the PWM control on the

primary side, crossing the isolation barrier. The PWM control input (pin 9, COMP) is driven

directly by the phototransistor’s collector (the emitter is grounded to GND) to modulate the

duty cycle (Figure 14, left-hand side circuit).

In applications where a tight output regulation is not required, it is possible to use a primary-

sensing feedback technique. In this approach the voltage generated by the self-supply

winding is sensed and regulated. This solution, shown in Figure 14, right-hand side circuit,

is cheaper because no optocoupler or secondary reference is needed, but output voltage

regulation, especially as a result of load changes, is quite poor.

Figure 14. Possible feedback configurations that can be used with the L6566BH

Vout

L6566BH

9

COMP

5 Vcc

L6566BH

9

COMP

Cs

Naux

24/51

TL431

Secondary feedback

Doc ID 16610 Rev 2

Primary feedback

AM11490v1

Share Link: