LB11872H 查看數據表（PDF） - SANYO -> Panasonic

零件编号

产品描述 (功能)

生产厂家

LB11872H

For Polygonal Mirror Motors Three-Phase Brushless Motor Driver

SANYO -> Panasonic 

LB11872H

6. Rotor Constraint Protection Circuit

This IC provides a rotor constraint protection circuit to protect the IC itself and the motor when the motor is constrained

physically, i.e. prevented from turning. If the FG signal (edges of one type (rising or falling edges) on the IN1 signal)

does not switch within a fixed time, output drive will be turned off. The time constant is determined by the capacitor

connected to the CSD pin.

< time constant (in seconds) > ≈ 30.5 × 1.57 × CCSD (μF)

If a 0.02μF capacitor is used, the protection time will be about 1.05 seconds.

To clear the rotor constraint protection state, the IC must be set to the stopped state or the power must be turned off and

reapplied. If there is noise present on the FG signal during the constraint time, the rotor constraint protection circuit

may not operate normally.

7. Phase Lock Signal

(1) Phase lock range

Since this IC does not include a counter or similar functionality in the speed control system, the speed error range in

the phase locked state cannot be determined solely by IC characteristics. (This is because the acceleration of the

changes in the FG frequency influences the range.) When it is necessary to stipulate this characteristic for the motor,

the designer must determine this by measuring the actual motor state. Since speed errors occur easily in states

where the FG acceleration is large, it is thought that the speed errors will be the largest during lock pull-in at startup

and when unlocked due to switching clock frequencies.

(2) Masking function for the phase lock state signal

A stable lock signal can be provided by masking the short-term low-level signals due to hunting during lock pull-in.

However, this results in the lock state signal output being delayed by the masking time.

The masking time is determined by the capacitor inserted between the CSD pin and ground.

< masking time (seconds) > ≈ 6.5 × 1.57 × CCSD (μF)

When a 0.022μF capacitor is used, the masking time will be about 225ms. In cases where complete masking is required,

a masking time with fully adequate margin must be used.

8. Initial Reset

To initially reset the logic circuits in start mode, the IC goes to the reset state when the CSD pin voltage goes to zero

until it reaches 0.63V. Drive output starts after the reset state is cleared. The reset time can be calculated to a good

approximation using the following formula.

< reset time (seconds) > ≈ 0.13 × CCSD (μF)

A reset time of over 100μs is required.

9. Current Limiter Circuit

The current limit value is determined by the resistor Rf inserted between the RF pin and ground.

ILIM = VL/Rf VL = 0.59V (typical) (during acceleration) and 0.37V (typical) (during deceleration)

10. Power Supply Stabilization

An adequately large capacitor must be inserted between the VCC pin and ground for power supply stabilization. If

diodes are inserted in the power supply lines to prevent destruction of the device if the power supply is connected with

reverse polarity, the power supply line levels will be even more easily disrupted, and even larger capacitors must be

used.

If high-frequency noise is a problem, a ceramic capacitor of about 0.1μF must also be inserted in parallel.

11. VREG Stabilization

A capacitor of at least 0.1μF must be used to stabilize the VREG voltage, which is the control circuit power supply.

The capacitor must be connected as close as possible to the pins.

12. Error Amplifier External Component Values

To prevent adverse influence from noise, the error amplifier external components must be located as close to the IC as

possible.

No.7257-10/11

Share Link: