Dimensions LB 1000-SI/SP2 (in mm. 1 mm = 0.0394 inch)
Front view
Left view
Secondary terminals
Terminal + : supply voltage + 15 V
Terminal M : measure
Terminal - : supply voltage - 15 V
Connection
Top view
Mechanical characteristics
• General tolerance
• Fastening
Recommended fastening torque
• Primary through-hole
• Connection of secondary
± 0.5 mm
4 slots ∅ 7 mm
4 M5 steel screws
4 Nm or 2.95 Lb. - Ft.
∅ 40 mm
Faston 6.3 x 0.8 mm.
Remarks
• IS is positive when IP flows in the direction of the arrow.
• Temperature of the primary conductor should not exceed
100°C.
• Dynamic performances (di/dt and response time) are best
with a single bar completely filling the primary hole.
LEM reserves the right to carry out modifications on its transducers, in order to improve them, without previous notice.
LEM Components
050816/1
Page 3/3
w w w.lem.com