LT3570(RevA) 查看數據表（PDF） - Linear Technology
零件编号
产品描述 (功能)
生产厂家
LT3570 Datasheet PDF : 20 Pages
| |||
LT3570
APPLICATIONS INFORMATION
compensation resistor, RC, is usually in the range of 5k to
50k. A good technique to compensate a new application
is to use a 50k potentiometer in place of RC, and use a
1nF capacitor for CC. By adjusting the potentiometer while
observing the transient response, the optimum value for
RC can be found. Figures 3a to 3c illustrate this process
for the circuit of Figure 1 with load current stepped from
100mA to 500mA for the buck converter. Figure 3a shows
the transient response with RC equal to 1.6k. The phase
margin is poor as evidenced by the excessive ringing in
the output voltage and inductor current. In Figure 3b,
the value of RC is increased to 5.75k, which results in a
more damped response. Figure 3c shows the result when
RC is increased further to 25k. The transient response
is nicely damped and the compensation procedure is
complete. The same procedure is used to compensate
the boost converter.
Soft-Start
The Soft-start time is programmed with an external capaci-
tor to ground on SS. An internal current source charges it
with a nominal 4.5μA. The voltage on the soft-start pin is
used to control the feedback voltage. The soft-start time
is determined by the equation:
tSS = 0.2 • CSS
where CSS is in nF and tSS is in ms. In the event of a
commanded shutdown, ULVO on the input or a thermal
shutdown, the capacitor is discharged automatically. The
soft-start will remain low and only charge back up after
the fault goes away and the voltage on SS is less than
approximately 100mV.
IOUT
500mA/DIV
IOUT
500mA/DIV
VOUT
200μs/DIV
3570 F03a
Figure 3a. Transient Response Shows Excessive Ringing
IOUT
500mA/DIV
VOUT
200μs/DIV
3570 F03b
Figure 3b. Transient Response is Better
VOUT
200μs/DIV
3570 F03c
Figure 3c. Transient Response Well Damped
3570fa
15
Share Link: 