For additional information, see the MPC5200B User’s Manual (MPC5200BUM).
1.3.4.1 Reset Configuration Word
During reset (HRESET and PORRESET) the Reset Configuration Word is latched in the related Reset Configuration Word
Register with each rising edge of the SYS_XTAL signal. If both resets (HRESET and PORRESET) are inactive (high), the
contents of this register are locked immediately with the SYS_XTAL clock (see Figure 3).
4096 clocks
SYS_XTAL
PORRESET
HRESET
RST_CFG_WRD
sample sample sample sample
sample sample sample sample
sample
sample
LOCK
Figure 3. Reset Configuration Word Locking
NOTE
Beware of changing the values on the pins of the reset configuration word after the
deassertion of PORRESET. This may cause problems because it may change the internal
clock ratios and so extend the PLL locking process.
1.3.5 External Interrupts
The MPC5200B provides three different kinds of external interrupts:
• Four IRQ interrupts
• Eight GPIO interrupts with simple interrupt capability (not available in power-down mode)
• Eight WakeUp interrupts (special GPIO pins)
The propagation of these three kinds of interrupts to the core is shown in the following graphic:
MPC5200B Data Sheet, Rev. 4
Freescale Semiconductor
15