EEPROM-Programmable, Quad,
Power-Supply Tracker/Sequencer Circuit
Table 5. Program Autoretry/Latch off
REGISTER
ADDRESS
09h
EEPROM MEMORY
ADDRESS
29h
BIT RANGE
DESCRIPTION
5
[4:2]
If 1, latch-on fault
If 0, autoretry
“000” autoretry timer value = 25µs
“001” autoretry timer value = 12.5ms
“010” autoretry timer value = 25.0ms
“011” autoretry timer value = 50.0ms
“100” autoretry timer value = 100.0ms
“101” autoretry timer value = 200.0ms
“110” autoretry timer value = 400.0ms
“111” autoretry timer value = 1600.0ms
Table 6. IN1–IN4 Threshold Settings
REGISTER
ADDRESS
00h
01h
02h
03h
04h
EEPROM MEMORY
ADDRESS
20h
21h
22h
23h
24h
BIT
RANGE
[7:0]
[7:0]
[7:0]
[7:0]
[7:0]
DESCRIPTION
IN1 Undervoltage Threshold
VTH = 1.0 + n x 20mV (if R08[7] = 0)
VTH = 0.5 + n x 10mV (if R08[7] = 1)
where n is the register content decimal representation. Note that VTH ranges
must be 1V to 5.5V and 0.5V to 3.05V, respectively.
IN2 Undervoltage Threshold
VTH = 1.0 + n x 20mV (if R08[6] = 0)
VTH = 0.5 + n x 10mV (if R08[6] = 1)
where n is the register content decimal representation. Note that VTH ranges
must be 1V to 5.5V and 0.5V to 3.05V, respectively.
IN3 Undervoltage Threshold
VTH = 1.0 + n x 20mV (if R08[5] = 0)
VTH = 0.5 + n x 10mV (if R08[5] = 1)
where n is the register content decimal representation. Note that VTH ranges
must be 1V to 5.5V and 0.5V to 3.05V, respectively.
IN4 Undervoltage Threshold
VTH = 1.0 + n x 20mV (if R08[4] = 0)
VTH = 0.5 + n x 10mV (if R08[4] = 1)
where n is the register content decimal representation. Note that VTH ranges
must be 1V to 5.5V and 0.5V to 3.05V, respectively.
IN1 Overvoltage Threshold
VTH = 1.0 + n x 20mV (if R08[7] = 0)
VTH = 0.5 + n x 10mV (if R08[7] = 1)
where n is the register content decimal representation. Note that VTH ranges
must be 1V to 5.5V and 0.5V to 3.05V, respectively.
______________________________________________________________________________________ 19