M34C02-R 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

M34C02-R

2 Kbit serial I²C bus EEPROM for DIMM serial presence detect

STMicroelectronics 

M34C02-R

3

Device operation

Device operation

The device supports the I2C protocol. This is summarized in Figure 5. Any device that sends

data on to the bus is defined to be a transmitter, and any device that reads the data to be a

receiver. The device that controls the data transfer is known as the bus master, and the

other as the slave device. A data transfer can only be initiated by the bus master, which will

also provide the serial clock for synchronization. The memory device is always a slave in all

communication.

3.1

Start condition

) Start is identified by a falling edge of Serial Data (SDA) while Serial Clock (SCL) is stable in

t(s the high state. A Start condition must precede any data transfer command. The device

continuously monitors (except during a Write cycle) Serial Data (SDA) and Serial Clock

c (SCL) for a Start condition, and will not respond unless one is given.

Produ t(s) 3.2

Stop condition

te c Stop is identified by a rising edge of Serial Data (SDA) while Serial Clock (SCL) is stable

le du and driven high. A Stop condition terminates communication between the device and the

so ro bus master. A Read command that is followed by NoAck can be followed by a Stop condition

to force the device into the Standby mode. A Stop condition at the end of a Write command

b P triggers the internal EEPROM Write cycle.

t(s) - O olete 3.3

Acknowledge bit (ACK)

c bs The acknowledge bit is used to indicate a successful byte transfer. The bus transmitter,

u O whether it be bus master or slave device, releases Serial Data (SDA) after sending eight bits

rod - of data. During the 9th clock pulse period, the receiver pulls Serial Data (SDA) low to

P t(s) acknowledge the receipt of the eight data bits.

lete duc 3.4

Data input

so ro During data input, the device samples Serial Data (SDA) on the rising edge of Serial Clock

b P (SCL). For correct device operation, Serial Data (SDA) must be stable during the rising edge

O teof Serial Clock (SCL), and the Serial Data (SDA) signal must change only when Serial Clock

Obsole(SCL) is driven low.

11/29

Share Link: