NG80960JD-66 查看數據表（PDF） - Unspecified
零件编号
产品描述 (功能)
生产厂家
NG80960JD-66 Datasheet PDF : 59 Pages
| |||
80960JD
Table 4. Pin Description — Processor Control Signals, Test Signals and Power (Sheet 2 of 2)
NAME
TDO
TRST
TMS
VCC
VCCPLL
VCC5
VSS
NC
TYPE
O
R(Q)
HQ)
P(Q)
I
A(L)
I
S(L)
–
–
–
–
–
DESCRIPTION
TEST DATA OUTPUT is the serial output pin for JTAG. TDO is driven on the falling
edge of TCK during the SHIFT-IR and SHIFT-DR states of the Test Access Port. At
other times, TDO floats. TDO does not float during ONCE mode.
TEST RESET asynchronously resets the Test Access Port (TAP) controller function
of IEEE 1149.1 Boundary Scan testing (JTAG). When using the Boundary Scan
feature, connect a pulldown resistor between this pin and VSS. If TAP is not used,
this pin must be connected to VSS; however, no resistor is required. See Section 4.3,
Connection Recommendations (pg. 22).
TEST MODE SELECT is sampled at the rising edge of TCK to select the operation of
the test logic for IEEE 1149.1 Boundary Scan testing.
POWER pins intended for external connection to a VCC board plane.
PLL POWER is a separate VCC supply pin for the phase lock loop clock generator. It
is intended for external connection to the VCC board plane. In noisy environments,
add a simple bypass filter circuit to reduce noise-induced clock jitter and its effects
on timing relationships.
5 V REFERENCE VOLTAGE input is the reference voltage for the 5 V-tolerant I/O
buffers. This signal should be connected to +5 V for use with inputs which exceed
3.3 V. If all inputs are from 3.3 V components, this pin should be connected to 3.3 V.
GROUND pins intended for external connection to a VSS board plane.
NO CONNECT pins. Do not make any system connections to these pins.
NAME
XINT7:0
NMI
Table 5. Pin Description — Interrupt Unit Signals
TYPE
I
A(E/L)
I
A(E)
DESCRIPTION
EXTERNAL INTERRUPT pins are used to request interrupt service. The XINT7:0
pins can be configured in three modes:
Dedicated Mode: Each pin is assigned a dedicated interrupt level. Dedicated inputs
can be programmed to be level (low) or edge (falling) sensitive.
Expanded Mode: All eight pins act as a vectored interrupt source. The interrupt pins
are level sensitive in this mode.
Mixed Mode:
The XINT7:5 pins act as dedicated sources and the XINT4:0 pins
act as the five most significant bits of a vectored source. The least
significant bits of the vectored source are set to 0102 internally.
Unused external interrupt pins should be connected to VCC.
NON-MASKABLE INTERRUPT causes a non-maskable interrupt event to occur.
NMI is the highest priority interrupt source and is falling edge-triggered. If NMI is
unused, it should be connected to VCC.
PRODUCT PREVIEW
11
Share Link: 