AD7492BRU-5(Rev0) 查看數據表（PDF） - Analog Devices

零件编号

产品描述 (功能)

生产厂家

AD7492BRU-5
(Rev.:Rev0)

1.25 MSPS, 16 mW Internal REF and CLK, 12-Bit Parallel ADC

Analog Devices 

CONVST

BUSY

CS

RD

DBx

tCONVERT

t2

t9

t10

t3

t4

t8

t5

t6

t7

Figure 9. Parallel Port Timing

AD7492

tCONVERT

CONVST

t2

t9

BUSY

DBx

DATA N

DATA N+1

Figure 10. Parallel Port Timing with CS and RD Tied Low

this mode a new conversion should not be initiated until 140 ns

after BUSY goes low. This acquisition time allows the track/hold

circuit to accurately acquire the input signal. As mentioned

earlier, a read should not be done during a conversion. This

mode facilitates the fastest throughput times for the AD7492.

Mode 2 (Partial or Full Sleep Mode)

Figure 11 shows AD7492 in Mode 2 operation where the ADC

goes into either partial or full sleep mode after conversion. The

CONVST line is brought low to initiate a conversion and remains

low until after the end of conversion. If CONVST goes high and

low again while BUSY is high, the conversion is restarted. Once

the BUSY line goes from a high to a low, the CONVST line has its

status checked and, if low, the part enters a sleep mode. The

type of sleep mode the AD7492 enters depends on what ever

way the PS/FS pin is hardwired. If the PS/FS pin is tied high,

the AD7492 will enter partial sleep mode. If the PS/FS pin is

tied low, the AD7492 will enter full sleep mode.

The device wakes up again on the rising edge of the CONVST

signal. From partial sleep the AD7492 is capable of starting

conversions typically 1 µs after the rising edge of CONVST. The

CONVST line can go from a high to a low during the wake-up

time, but the conversion will still not be initiated until after 1 µs.

We recommend that conversion should not be initiated until at

least 20 µs of the wake-up time has elapsed. This will ensure that

the AD7492 has stabilized to within 0.5 LSB of the analog input

value. After 1 µs, the AD7492 will have only stabilized to within

approximately 3 LSB of the input value. From full sleep this wake-

up time is typically 500 µs. In all cases the BUSY line will only go

high once CONVST goes low. Superior power performance can

be achieved in these modes of operation by waking up the

AD7492 only to carry out a conversion. The optimum power

performance is obtained when using full sleep mode as the ADC

comparator, Reference buffer and Reference circuit is powered

down. While in partial sleep mode, only the ADC comparator is

powered down and the reference buffer is put into a low power

mode. The 100 nF capacitor on the REF OUT pin is kept charged

up by the reference buffer in partial sleep mode while in full

sleep mode this capacitor slowly discharges. This explains why

the wake-up time is shorter in partial sleep mode. In both sleep

modes the clock oscillator circuit is powered down.

CONVST

BUSY

tCONVERT

tWAKEUP

CS

RD

DBx

REV. 0

Figure 11. Mode 2 Operation

–11–

Share Link: